A) wall-guided
B) tumble-guided
C) spray-guided
D) swirl-guided
Correct Answer
verified
Multiple Choice
A) more components compared to port fuel injection
B) less need for extra fuel for acceleration
C) higher cost
D) NOx storage catalyst may be needed
Correct Answer
verified
Multiple Choice
A) reversed
B) interrupted
C) lower
D) higher
Correct Answer
verified
Multiple Choice
A) A
B) B
C) C
D) D
Correct Answer
verified
Multiple Choice
A) 100 to 110 V
B) 12 to 14 V
C) 200 to 220 V
D) 50 to 90 V
Correct Answer
verified
Multiple Choice
A) on the fuel injectors
B) on the intake valves
C) on the exhaust valves
D) Both A and C
Correct Answer
verified
Multiple Choice
A) the air-fuel mixture being evenly distributed in the combustion chamber
B) black smoke from the exhaust
C) a rich air-fuel mixture near the spark plug tip
D) None of these
Correct Answer
verified
Multiple Choice
A) EFI
B) DI
C) UIDI
D) SIDI
Correct Answer
verified
Multiple Choice
A) a vacuum-biased regulator
B) an electric pressure control valve
C) a non-vacuum-biased regulator
D) a mechanical regulator at the inlet to the fuel rail
Correct Answer
verified
Multiple Choice
A) improved fuel economy
B) decreased throttle response
C) able to use lower-octane gasoline
D) higher engine efficiency
Correct Answer
verified
Multiple Choice
A) Stoichiometric
B) Homogeneous
C) Knock protection
D) Stratified
Correct Answer
verified
Multiple Choice
A) high pressure mode
B) 60 PSI
C) low pressure mode
D) acceleration mode
Correct Answer
verified
Multiple Choice
A) three-lobed cam
B) electric motor
C) single flat sided cam
D) square-lobed cam
Correct Answer
verified
Multiple Choice
A) electricity (DC motor)
B) the crankshaft
C) the camshaft
D) electricity (AC motor)
Correct Answer
verified
Multiple Choice
A) Directly into the combustion chamber
B) Into the intake manifold near the intake valve
C) Above the intake port
D) In the exhaust port
Correct Answer
verified
Multiple Choice
A) higher
B) colder
C) related
D) lower
Correct Answer
verified
Multiple Choice
A) The ball-ends deform when tightened and will not seal if reused
B) The torque needed to remove the lines causes the lines to be damaged
C) The high-pressure lines are part of the high-pressure pump and must be replaced as an assembly
D) All of the above
Correct Answer
verified
Multiple Choice
A) Stratified heating mode
B) Homogeneous stratified mode
C) Stratified mode
D) None of these
Correct Answer
verified
Multiple Choice
A) 500 to 2,900 PSI
B) 2,000 to 5,000 PSI
C) 90 to 150 PSI
D) 35 to 45 PSI
Correct Answer
verified
Multiple Choice
A) 25
B) 6
C) 50
D) 10
Correct Answer
verified
Showing 1 - 20 of 22
Related Exams